|
|
P.P.Film
CLEARGUARD is installed in many race and rally cars in U.S.A. such as almost all NASCAR vehicles. If it will protect the paint of a vehicle traveling over 300 km per hour, just think of what it will do to you on the highway at 100 km. per hour!
CLEARGUARD Ideally suited for off road vehicles to protect all vulnerable areas of the vehicle against hazardous objects.
3M does have a specific test for this product using a device known as a Gravelometer which is designed to fire one half point of gravel at painted surfaces at a speed of 50 - 100 km. per hour for about 10 seconds. The areas covered by the film always emerged unscathed while uncovered panels suffer from pitting and chipping.
BOOK NOW >>!!!
CLEARGUARD Frequently Asked Questions
Q. Will the Clear GUARD harm the painted surface if the film is removed?
A. If the film is properly applied to a fully cured painted vehicle, it can be removed, usually in one piece, without damaging paint surfaces beneath the film.
Q. Can the CLEARGUARD be applied over a vehicle that has had the paint touched up?
A. We recommend that any repainted surfaces on your vehicle be professionally painted and fully cured before applying the CLEARGUARD. If you have touched up scratches or chips with a tube of 'touch-up’ paint and then apply the CLEARGUARD over it, the film mil protect that area until It Is removed. If the CLEARGUARD is removed, it is possible that the area around the non- professional touch-up paint could peel off.
Q. Will the paint smear if the CLEARGUARD is applied over a newly painted vehicle?
A. The paint on a newly painted vehicle must be cured according to manufacturer's recommendations. Your body shop should be able to provide you with this Information.
Q. Can I cover the whole vehicle with the CLEARGUARD?
A. It is possible, but the application would be difficult and expensive. This product is really intended for the most vulnerable areas of the vehicle.
Q. Howls the CLEARGUARD film maintained?
A. Once applied, refrain from washing the vehicle in an automated car wash for 24 hours. Washing after that time presents no problem, and no special care need to be taken for the film.
Q. Can l use wax over the CLEARGUARD?
A. Yes. When waxing the vehicle, some wax may build up along the film edges. This can easily be removed when dry with a soft brush such as an old toothbrush. Do not use any waxes containing dyes or waxes that are not recommended for urethanes. Abrasive polishes and/or rubbing compounds are not to be used.
Q. lithe CLEARCIUKD is removed from the vehicle, can it be re-used?
A. Once the film has been applied and set, the adhesive will not stick a second time.
Q. Does the CLEARGUARD resist yellowing?
A. Yes, the film is constructed of thermoplastic urethane, a tough, conformable material that is covered by a clear coat layer. The film and clear coat layers contain UV inhibitors to counteract harmful ultraviolet rays that can cause yellowing.
|
|
|
